Motor, Pentair SF/WF-4,1.0hp,115v/208-230v,1-Spd,SQFL,Almond|355022S

💧 Motor, Pentair SF/WF-4,1.0hp,115v/208-230v,1-Spd,SQFL,Almond

Made by Pentair, manufacturer part number 355022S. It is listed for the equipment shown below, so check the model on your own unit against that list.

✅ Listed for

• Pentair Sta-Rite SuperMax/SuperFlo Pumps
• Pentair WhisperFlo® High Performance Pool Pump

Pentair replacement pool pump motor – 1 HP, 115V / 230V, single speed

⚙️ What this motor is

This is a replacement motor only, not a complete pump. It is a square flange motor, which you can recognise by a square plate on the pump end with a bolt through each corner. It runs on 115V / 230V, single speed. It bolts to the wet end you already have, so the pump housing, impeller and plumbing stay where they are.

✅ Check these before you order

• Compare total horsepower, not horsepower. Multiply the horsepower on your old motor’s label by the service factor next to it, and compare that figure. This motor is rated 1 HP.
• Mounting. Square flange, C-face and thru-bolt motors are not interchangeable and there is no adapter between them, so check yours matches before ordering.
• Voltage. This motor is 115V / 230V. Read it off the old motor’s label rather than assuming from the wiring – a spa wired for 240V can still run a 120V pump.

🔧 When you fit it

• Fit a new shaft seal at the same time. A failed shaft seal lets water into the motor and is the most common reason a motor dies. Reusing the old one on a new motor is the quickest way to ruin it.
• Rotation. Pool and spa motors turn counter-clockwise seen from the shaft end, shown on the label as CCW or CCWPE. They cannot be reversed by swapping wires, so check the old label if it says anything different.
• Keep the horsepower the same unless you are changing the impeller too – the impeller is matched to the motor’s output.

🔩 Technical specifications